Do you need wall plugs for brick?

Wall plugs are essential when hanging cabinets, mirrors and shelves – in fact anything you want to attach to your walls. A normal screw will not securely stay in plasterboard or masonry without a wall plug.

Is it OK to drill into basement wall?

A: Drilling into concrete isn’t impossible — special masonry drill bits are available — but you’re right to be cautious about drilling holes in the walls of a dry basement. … Toggle (or Molly) bolts will work if there is about an inch of space between the concrete and the drywall.

How much weight can concrete wall hold?

As per standards published in 2003 by ASTM, an international building standards non-profit, all concrete blocks must support at least 1,700 pounds of weight per square inch (PSI).

Are concrete blocks load-bearing?

Their distinctive properties of durability and strength make them an ideal and cost-effect solution for all types of load–bearing walls. Dense aggregate concrete blocks are manufactured from cement, sand and aggregates.

How much weight can I hang from a stud?

between 80 and 100 lbs.

How much weight can a 2×4 stud wall support?

30,000lbs.

What is stronger 2×4 or 2×6?

For example, a 4-foot section of wall would have three 2x4s, but only two 2x6s. … In bending, however, such as from a wind load, a 2×6 wall is considerably stronger. In tall walls, where column buckling might be a factor, a 2×6 wall would be stronger if a structural sheathing was used.

How do you tell if your walls are 2×4 or 2×6?

Open a door and measure the distance from the outside edge of the outside trim to the inside edge of the inside trim. This distance will be a little more than 8 inches if you have 2-by-6-inch framing and a little more than 6 inches if you have 2-by-4-inch framing.

How much does a 12 ft 2X6 weight?

Want to pack around 12 foot long 2×6 lumber? In Hem-Fir, it will weigh 18.